By Norm Grusnick, P.Eng • Sales Manager, ECCO Supply
New digital VAV diffusers with enhanced features are helping to fuel the growth of these systems. They are often now considered as an alternative to conventional VAV for smaller office renovation projects. While VAV diffusers operate in a similar manner to conventional VAV, a different ductwork design approach may be needed. VAV diffuser systems are pressure dependent, so the static pressure in ductwork has a direct impact on performance. VAV diffusers control the space temperature by regulating the airflow to the space with an integral air damper located behind the diffuser face.
The ductwork design can have a significant impact on the performance of a VAV diffuser system. Low pressure ductwork layouts designed with low loss fittings, 1.5 centreline elbows, and smooth tapered transitions can be sized to avoid sudden drops in system pressure and will perform better. Conventional VAV system ductwork is typically sized using the equal friction method, which as its name implies, is sized for an equal pressure loss (per linear foot) along its entire length. This method, however, may not be suitable for VAV diffusers, particularly for long ductwork runs with several bends as the static pressure will be significantly higher at the start of the run compared to the end, potentially causing noise issues at the first diffusers on the runout. Sizing the ductwork using the static regain method solves these issues as this method produces a duct system with a more or less uniform static pressure along its entire length, setting up good conditions for the VAV diffusers to operate.
An issue with the static regain method is that it’s a more complicated and time consuming procedure compared to the equal friction method, which is very straightforward when done using “ductulator” tools.
To help with static regain sizing there are many software tools, available from various sources, that can calculate the duct static pressure at any point along the ductwork run—so which method should be applied and when.
To begin with, there is no reason to size the main duct run using the static regain method, unless the engineer is trying to design a highly energy efficient duct system. The runouts to the floors should be fitted with pressure control dampers so static regain sizing may only be necessary from this point out to the zones. Duct runs with just a few elbows and transitions can usually be sized using equal friction without many issues, as long as the static pressure differential between the first and last VAV diffuser is no more than about 0.2 in water gauge. To put this into context, ductwork is typically designed in 0.08 to 0.1 inch w.g per 100 ft. so over 200 ft of ductwork would be needed to reach this differential limit. In contrast, a 10 inch, 90 degree elbow will have the same pressure drop as 70 feet of ductwork.
So, ductwork length isn’t the limiting factor. It is the number of elbows and fittings and their quality that determine whether a duct system that is sized using the equal friction method will successfully work with VAV diffusers. To summarize, if ductwork runs are relatively straightforward, equal friction sizing should give good results with VAV diffusers. For more complex duct systems, consider sizing the ductwork with static regain software tools. ■
